Kanga mini Loader Atachments
4/1 Bucket
Post Hole Digger
Augur Sizes: 150mm, 225mm, 300mm, 450mm, 600mm
Trencher
Rotary hoe
Road Broom
Ripper
Angle Back fill Blade
Digga Power Rake
Connecting atachments
Turn off the Kanga, wiggle back and forth levers located on top of the Kanga Loader to release the hydraulic pressure from the joiners. You should be able to push the poppets in on both male and female joiners with your finger. Machine is now ready to be connected to a atachment.
The attachments have the same joiners to match the kanga's. Please note that the sun and heat can increase pressure in the line as the oil heats up and expands, so you will need to release the pressure on the attachment as well. To do this you don't have a lever to wiggle, so you must release the pressure by pushing the ends of the hoses to open the poppets. Warning, oil will spray out so put a rag over fitting. The female fitting will require a pin to reach the poppet inside, being careful not to damage the tips.
Connecting the joiners by simply pulling back the outer sleeve on the female fitting and inserting the opposing hydraulic line with the male fitting into it. The snap ring should return to it's rest position and the lines should not be able to be pulled apart, repeat for the second set in opposite direction.
Disconnecting hydraulic lines - turn off Kanga, wiggle levers to release pressure, pull back the outer sleeve on the female fitting releasing the male fitting.
